Technical Specifications for Electrotap T200 Scaler

Physical Attributes

• Dimensions: 1 3/8in (37mm) x 1 1/4in (32mm) x 1/2 " (11mm)
• Solder Mask Color: Green
• Protective Rubber/Foam Padding on the bottom surface.
• Temperature Range: 0C to 70C (32F to 157F)

Ordering Information

• Screw-Pots, Full Version (with input cable) - T200A
• Screw-Pots, Project Version (no cables, no connectors, adhesive padding provided individually) - T200AP
• Right-Angle Knob-Pots, Full Version (with input cable) - T200B
• Right-Angle Knob-Pots, Project Version (no cables, no connectors, adhesive padding provided individually) - T200BP

Electrical Specifications

• Voltage Source, Voltage Input Range, Voltage Output Range: 0-5 Volts
• Minimum Current Source: 5mA
• Gain Range: 1-50x input
• Offset Range: 0-5 Volts
• Connector Layout (Pin 1 is indicated by an arrow on the top of the connector)
  - Pin 1: Ground (from interface )
  - Pin 2: Sensor Output, X-Axis
  - Pin 3: 5 Volts (from interface)

Cable Specifications

• Electrotap P/N: CAB-LF32LF3-3
• 3 foot (approximately 1 meter) premium quality Canare L-4E5C star-quad cable with braided shielding.
• Both end connectors are a 3-pin female locking Molex connector.
• Molex connector layout:
  - Pin 1: Ground
  - Pin 2: Sensor (X) Output
  - Pin 3: 5 Volts
• This cable can be used to connect an Electrotap sensor to the input of the Scaler. The cable that ships with the sensor can then be used to connect the scaler to the Teabox..

Application Examples

• Amplifying accelerometers to measure tilt.
• Amplifying temperature sensors to get higher resolution within a smaller range. Good for making a temperature sensor hypersensitive, i.e. to sense human touch or breath.
• Amplifying light sensors.
• Improving the results of non-Electrotap sensors when used with the Teabox.